Components are choosen from Cisco Packet Tracer tool and the code is written in Python for the controllers. That is actually the goal to this experiment. PRACTICAL 1: CREATING AN IOT TOPOLOGY The beginning of every practical is to get acquainted to the equipment being used. Obviously you need at least two controllers for each room that are communicating to each other via the home gateway. The practicals shall be done on CISCO packet tracer, a powerful simulator that permits real life simulations of networking problems and in our case IoT challenges. Obviously you need at least two controllers for each room that are communicating to each other via the home gateway to transmit information between these two rooms using WiFi. Therefore, we assume to have a home gateway to transmit information between these two rooms using WiFi. In this example we assume that the sensors and the alarrm are in one room, whereas the fan and the siren are in another room. Meantime, the motion sensor checks the movement in the room and in case of detecting any movement a siren should start warning. When the temperature goes back under the certain set (below 25 degree Celsius), then the fan should go off and the alarm should stop. When the temperature goes above a certain value ( for example above 25 degree Cesius) then the alarm goes off and the fan starts to run in its maximum speed. The temperature sensor is detecting the ambient temperature of the room, while the motion sensor checks if there is any movement in the room. examples, including Internet of Things (IoT) with this powerful networking simulation tool. Also, we consider to have an alarm, a fan and a siren. We have two sensors which are a temperature sensor and a motion sensor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |